- Can use the flow sensor with an input power supply of from 12 to 24 VDC (permissible voltage fluation +10%).

The amplifier protection structure conforms to IP67.

- Can set the lower limit of the flowrate. If the flowrate falls below this limit, the red LED (NG) turns on, and contact signal output is given to

- notify the operator of the critical situation.

Analog output (4 to 20 mA) proportional to the flowrate is issued.

- In the case of low pressure specifications, you can check the flow of fluid by observing the rotor rotation.

- In the case of high pressure specifications, you can measure the flowrate 25MPa. (except FS-1) For FS-2, 3 and 6,8 excluding , be sure to use

it with the cap B (for high pressure) mounted in position. (Cap B (for high pressure) is mounted when shipped from the factory)lo,

- Can use the sensor at the desired installation postion (horizontal, vertical or tited position) the desired inflow directioiin

Remove the cap from the front of the main body, and to clean the rotor by air.

‍